Hello,
I have identified an issue in the documentation and the instructions provided within the application (version 5.3.6) regarding the procedure for putting the ONLYKEY into configuration mode.
The current instructions state:
“Step 2. Hold down button #6 on your OnlyKey for 5+ seconds and release. The light will turn off. You will notice the OnlyKey flashes red in config mode.”
Please refer to this screenshot for reference.
Following these instructions, however, causes the ONLYKEY LED to simply turn off without entering configuration mode. To activate config mode, it is necessary to re-enter the PIN code. Once the PIN is re-entered, the LED exhibits a “fade-in, fade-out” red behavior.
Additionally, when copying and pasting the text from the application itself, the instructions appear as follows:
“Step 2. Hold down button #6 on your OnlyKey for 5+ seconds and release. Hold down button #1 on your OnlyKey DUO for 10+ seconds and release. The light will turn off. If a PIN was previously set, re-enter the PIN to enter config mode. You will notice the OnlyKey flashes red in config mode.”
As you can see, there is an inconsistency between what appears on the application’s GUI and what we get when copying the text from the same GUI. My guess is that a bug was introduced when you add support for the ONLYKEY DUO (I am a developer for 26 years…): some kind of conditional printing based on the device (OnlyKey vs OnlyKey Duo).
Thank you for addressing this issue. Please let me know if further clarification or additional details are needed.
Best regards,
Denis